Amantii WM-50 Instruções de Operação descarregar pdf (Página 29)

REMOTE CONTROL OPERATION

1. For remote to function make sure the heater is plugged-in

and mains power switch located on the bottom right hand

side is at position I.

2. When operating the remote make sure you point the

remote to the centre of the heater unit and make sure

each time you press the button the LED indicator located

on top right hand corner of the remote blinks. The buzzer

inside the unit will beep once; if the LED fails to blink

check the batteries. It takes some time for the receiver

to respond to the transmitter. Do not PRESS the buttons

more than once within two seconds for correct operation

3. Power On “

“ button: The power-on button at top left

corner of the remote is the mains ON/OFF power button.

This will turn off all the functions and the heater will be in

standby mode.

4. Flame Power On button

: This button controls both

the amber and blue colour ﬂame. Press this button once

to turn ON the ﬂame effect. Once the ﬂame effect is ON

use the + and – buttons as explained below to adjust the

ﬂame brightness as desired. Press this button again to

turn OFF the ﬂame effect.

• The RED

-5

buttons control the

brightness of the ] Amber fame.

To increase the brightness / ﬂame height,

press and release the

button.

Each time you press this button the brightness

will increase by a small amount, until the

maximum is reached.

To decrease the brightness / ﬂame height,

press and release the

-5 button.

Each time you press this button the brightness

will decrease by small amount, until the

minimum brightness is reached.

The BLUE

-5

buttons control the

brightness of the Blue fame.

To increase the brightness / ﬂame height,

press and release the

button.

Each time you press this button the

brightness will increase by a small amount,

until the maximum is reached.

To decrease the brightness / ﬂame height,

press and release the

-5

button.

Each time you press this button the brightness

will decrease by small amount, until the

minimum brightness is reached.

You can mix the amber and the blue ﬂame to

create a realistic ﬂame effect.

5. HEATER

Button: This button is the

heater ON/OFF button. Press this button to

turn the heater ON. The heater will always

start at high heat setting 2000W. To turn OFF

the heater press this button again.

HIGH button: Press the high button to switch

the heater to high heat setting 2000W.

LOW button: Press the high button to switch

the heater to LOW heat setting 1000W.

ROOM TEMP button: Press the high button to

switch the heater to AUTO mode. Under this

mode the heater will operate in similar way as

explained above for the manual operation.

6. To turn OFF the heater unit completely press

the “

“ button once.

Realistic Flame Effect:

The ﬂame effect is controlled by LEDs; the

LEDs are non-replaceable type but have been

manufactured to last for long life.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Comentários a estes Manuais

Sem comentários

Amantii WM-50 Instruções de Operação Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com Lareiras Amantii WM-50